You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
Option to reduce baud rate for burning firmware #7
Thanks for this great tool! When trying to burn the firmware to an Adafruit Feather board, I was running into continuous problems. It turned out that some USB chips require a slower baud rate, like 115200 baud, see also here: cnlohr/espusb#8
It would thus be good to be able to set the baud rate in the configuration, so that you can use e.g.
A quick solution would be locate the json file located in uPiotMicroPythonTool/boards an edit the --baud parameter manually. You should edit the file corresponding to your board/firmware
Thanks, I found that in parallel and tried, but it did not really help. Currently, ampy on the command-line works fine, but the same functionality inside Sublime Text does not.
That is a pity, because in theory this plug-in is exactly what I need - a Sublime-based integrated workflow for MicroPython development that works via the USB UART.
Has anybody this running with Adafruit Feather boards (ESP8266)?
Activity
gepd commentedon Jun 7, 2018
A quick solution would be locate the json file located in
uPiotMicroPythonTool/boardsan edit the--baudparameter manually. You should edit the file corresponding to your board/firmwaremfhepp commentedon Jun 8, 2018
Thanks, I found that in parallel and tried, but it did not really help. Currently, ampy on the command-line works fine, but the same functionality inside Sublime Text does not.
That is a pity, because in theory this plug-in is exactly what I need - a Sublime-based integrated workflow for MicroPython development that works via the USB UART.
Has anybody this running with Adafruit Feather boards (ESP8266)?
gepd commentedon Jun 8, 2018
This plugin uses a modified version of ampy, but it shouldn't be a problem.
You are having problem to burn the firmware or to run the ampy commands?