You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
You know, when you create an address, PyBitmessage will generate a maximum TTL pubkey message for each of them. This takes a bit of time. If you shut down it down, it will wait until all the messages are created before closing the window. I suppose this happened to you but I'll still do the test shortly.
I tested it and it's as I suspected. After the pubkeys are send out (on my 7 year old mac mini it takes maybe 10 minutes) the CPU usage drops again. So all is ok and it's a UI question (the UI could indicate to the user better what it's doing now). I'll leave this open for reference and close it once I do the UI change.
Activity
PeterSurda commentedon May 4, 2016
I'll look at it. I tested it on 10.7.x and 10.11.x and it worked fine, but I haven't tried deterministic addresses recently.
PeterSurda commentedon May 5, 2016
You know, when you create an address, PyBitmessage will generate a maximum TTL pubkey message for each of them. This takes a bit of time. If you shut down it down, it will wait until all the messages are created before closing the window. I suppose this happened to you but I'll still do the test shortly.
PeterSurda commentedon May 6, 2016
I tested it and it's as I suspected. After the pubkeys are send out (on my 7 year old mac mini it takes maybe 10 minutes) the CPU usage drops again. So all is ok and it's a UI question (the UI could indicate to the user better what it's doing now). I'll leave this open for reference and close it once I do the UI change.